Why does running Simulink in rapid acceleration mode cause a compiler error indicating that the line is too long?
조회 수: 18 (최근 30일)
이전 댓글 표시
MathWorks Support Team
2017년 6월 20일
편집: MathWorks Support Team
2021년 9월 2일
I have a model that I would like to run in rapid acceleration mode. However, when I attempt to run it, I get a compiler error, culminating in the following lines:
model_name.c:134 compiler limit: line too long (more than 20197 chars)
gmake: *** [model_name.obj] Error 1
I tried moving the files to a shorter directory, but that had no effect. What is causing this issue?
채택된 답변
MathWorks Support Team
2021년 8월 17일
편집: MathWorks Support Team
2021년 9월 2일
This error may occur if the you do not have any installed/configured compilers (as may be verified by the output of the command "mex -setup"), in which case MATLAB defaults to lcc.
The issue can be corrected by installing a supported compiler. Supported compilers are listed in the documentation at the following link:
댓글 수: 0
추가 답변 (0개)
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!