Update internal mechanics parameters of Simmechanics Revolute joint while simulation is in progress

조회 수: 3 (최근 30일)
Leslie Castelino
Leslie Castelino 2017년 6월 16일
댓글: Sanil Mhatre 2017년 8월 4일
How do I keep updating the value of spring stiffness and damping coeff. in a Revolute joint (Simmechanics 2nd generation) while the simulation is running? For eg. Stiffness from 1-5 sec of simulation time is 10 Nm/rad and from 6-10 sec it is 20 Nm/rad.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Sagar Doshi
Sagar Doshi 2017년 6월 20일
I don't think it is possible. You cannot tune most Simscape Multibody block parameters during simulation. This doc link might be helpful.

카테고리

Help Center 및 File Exchange에서 Assembly에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by