Using system() or unix() or dos() or ! inside simulink block to deploy to hardware
조회 수: 2 (최근 30일)
이전 댓글 표시
Hello guys
Im using simulink to deploy in a raspberry pi.
If a true is read in a gpio pin, i want to execute a command on raspbery pi command line. e.g.: sudo halt
Tried to use system(), unix(), dos(), and !, in a matlab function block without success.
Any ideas ?
:)
댓글 수: 0
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Raspberry Pi Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!