How to test my filter design?
조회 수: 3 (최근 30일)
이전 댓글 표시
I had desined a band pass filter with Agilent VEE pro 9.2 and I would like to now how to test this design with an input signal and how to check the output.
댓글 수: 0
채택된 답변
Indira
2011년 3월 15일
You can design a filter with the same specifications using FDAtool in Simulink...Then you can generate a signal to try the filter... Both filters must have the same response...
추가 답변 (1개)
Honglei Chen
2011년 3월 16일
In general, a filer is designed according to specifications such as passband, stopband, passband ripple, stopband attenuation, etc. If you could get the coefficients from your design, you can use FVTOOL to plot your response and then see if it satisfies your specification.
댓글 수: 1
Mohini modi
2016년 7월 24일
You ca try convol the filter with itself and check if the filter is meeting it specification as you wanted
참고 항목
카테고리
Help Center 및 File Exchange에서 Filter Design에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!