Best way to find local minimum and maximum (where derivatives = 0) without using toolboxes?
조회 수: 11 (최근 30일)
이전 댓글 표시
Hi,
I want to find the local maximums and minimums of a data set. I do not have any toolbox. Is there any way to do that except comparing every value with the next and previous values?
Thanks.
댓글 수: 2
Alasdair Gerrard
2016년 12월 2일
Is your data in an array? If so you can use max('your data') and min('your data'). Or are you interested in the rate of change max and min (i.e. where the derivatives are 0)?
채택된 답변
KSSV
2016년 12월 2일
YOu can use min and max. Also you can sort the array using sort either ascending or descending and pick either first or last respectively.
댓글 수: 2
추가 답변 (1개)
Andreas Goser
2016년 12월 2일
It very much depends on the nature of your signal. Assuming this is measured data, you might want to filter noise first. There are multiple ways to do so. Then, the signal might have only very few local maxima or many. Depending on this and the topology, you might want to do some curve fitting first. Making a calculation with "derivatives being 0" - also very tricky. E.g. in a 12V signal and 1Hz frequency, is an increase from 7.9 Volt to 8.0 V a relevant increase, or pretty much flat for you. This means you would not compare with differences of exact zero, but within a bandwidth.
Saying all that, a lot of smartness is in the toolboxes for that purpose. Consider using them and not re-invent the wheel.
참고 항목
카테고리
Help Center 및 File Exchange에서 Multirate Signal Processing에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!