How to set up Altera Cyclone V SoC Development Kit for Embedded Coder Support Package?
조회 수: 9(최근 30일)
I have performed steps successfully until step 9 -connect the hardware
but matlab unable to connect the device using JTAG (time-out error) how i need to setup the hardware? how to config the different jumpers on the board?
Wang Chen 2016년 12월 8일
편집: Wang Chen 2016년 12월 8일
Do you mean the serial connection (USB UART) is timing out?
Please set the jumper setting the same as the picture in page 12 of the board User Guide. Please make sure J28, J29, J30 is set the same as the picture.