PID block and error with it

조회 수: 1 (최근 30일)
David H
David H 2016년 11월 14일
답변: Arkadiy Turevskiy 2016년 12월 7일
Hi!
I am trying to run this and I always get the same error. Can anyone explain where I went wrong? Thanks!
Errors: Output port 1 of 'Testing_PID/Pulse Generator' is not connected. <-- where should I connect this one?
Model 'Testing_PID' is using a default value of 0.2 for maximum step size. You can disable this diagnostic by setting 'Automatic solver parameter selection' diagnostic to 'none' in the Diagnostics page of the configuration parameters dialog

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Arkadiy Turevskiy
Arkadiy Turevskiy 2016년 12월 7일
Why did you place the pulse generator block in the model? If you do not really need it, delete it. You are getting the error because this block is not connected to anything.

카테고리

Help Center 및 File Exchange에서 Configure and View Diagnostics에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by