Why the 48 pulse GTO-Based STATCOM doesn't work effectively on my model?
조회 수: 3 (최근 30일)
이전 댓글 표시
This is my observed bus voltage in per unit before installing STATCOM.
However, bus voltage after installing STATCOM only increase reactive power level since there is still the same ripple. How can I eliminate the ripple on voltage? The setting in STATCOM is the same as follows: https://www.mathworks.com/help/physmod/sps/powersys/ug/gto-based-statcom.html
Thank you very much!
댓글 수: 0
답변 (1개)
Joel Van Sickel
2023년 5월 2일
This is an effort to clean up Matlab Answers. Unfortunately, this response is likely to late to be of help to this question:
For this type of question, a model would need to be shared to better understand why a certain approach might not be working.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Power Converters에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!