Simulink shows only the last 2 second of simulation time

조회 수: 5 (최근 30일)
Alzapoa
Alzapoa 2012년 2월 9일
편집: Matt J 2013년 10월 6일
Hello,
My Simulink model of an induction machine run about 2 second even if the simulation time is 20 sec. any idea on that?
The model is include of 3-phase to d-q model and then transforming to rotor reference model. the last step is deriving currents and applying the electrical torque and the mechanical torque has not been implemented yet. sot machine is working in no-load condition.
Regards,

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Andreas Goser
Andreas Goser 2012년 2월 9일
Please verify the scope setting: Parameters - Data History - Limit Data Point to last.
The default is it is checked and limited to 5000 points.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Building and Simulating Electronic, Mechatronic, and Electrical Power System Networks에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by