boost::fil​esystem::c​anonical error ?

Hi all,

I am using matlab R2015a and I am using different codes in different paths, so I used addpath. However, when it comes to the next iteration or the path changes, Matlab gives me an error "boost::filesystem::canonical"

I was looking in the forum, but I can not find a solution yet.

Thanks

[Balam Willemsen]

Were you by any chance using the Parallel Computing Toolbox? I have seen boost::filesystem::canonical when a parallel pool is left open by mistake (e.g. when one of the workers encounters an error).

Responding here even though the question was from a few months back so that Google can find the answer for me next time it happens! ;)

Balam

[Thomas Pfau]

Even though this is quite old, I'm wondering, whether anyone found a solution to this issue. I'm experiencing exactly this behaviour in 2015b on a piece of code that works fine with 2014b and 2016b. Closing the pool and reopening it doesn't change the behavior. I'm a bit at a loss here, since this is not thrown as an error but just stops execution completely....