No output on scope

Hi, I'm trying to model an RFID tag in this block that modulates a signal if input power is above a certain threshold. However when I run the simulation, there is no output of scope. The power meters change showing the values update, however scope has no trace, no even the first one which is just supposed to plot a sin wave.

Answer 1

[Tushar Sinha]

Hi Nasif,

I understand that you are not able to see any plot in the Simulink Scope Block. However, if you refer to the following MathWorks documentation link, it talks about the same issue and what troubleshooting steps you can take to resolve it:

plots-not-visible-in-simulink-scope-block

I hope this helps resolve the issue.

Thanks,

Tushar