Fixed-Point Designer tells me that "Magnitude-Angle to Complex" Block is not supported. Why?

조회 수: 1 (최근 30일)
Arne
Arne 2015년 9월 18일
답변: Kiran Kintali 2020년 10월 19일
Hi, I am trying to convert a Simulink model that contains several "Magnitude-Angle to Complex" blocks to HDL code. When running the Fixed Point Designer tool it fails at step 1.3 "Address unsupported blocks". However, "Magnitude-Angle to Complex" does support fixed point designs if the approximation method is set to "CORDIC", which I did. Are there any other settings that are needed? Or is there a bug in Fixed Point Designer? Thanks, Arne
  댓글 수: 1
Aditya Dodda
Aditya Dodda 2020년 9월 3일
Hi Arne, Thanks for bringing the issue to our attention. You are correct that the block "Magnitude-Angle to Complex" in CORDIC supports fixed-point. The issue is fixed in the new version of Fixed-Point Tool.

댓글을 달려면 로그인하십시오.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Kiran Kintali
Kiran Kintali 2020년 10월 19일
This issue is resolved in R2016b release.

카테고리

Help Center 및 File Exchange에서 Fixed-Point Designer에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by