zedboard fpga in loop
조회 수: 5 (최근 30일)
이전 댓글 표시
Hello, Has anybody used zedboard in fpga in loop simulation? If so are there any documents or explainitions? Thank you
댓글 수: 0
답변 (2개)
Tao Jia
2015년 8월 24일
There is a generic tutorial at: http://www.mathworks.com/help/hdlverifier/examples/verify-hdl-implementation-of-pid-controller-using-fpga-in-the-loop.html?prodcode=ES&language=en.
Note that zedboard only supports JTAG connection with the host when using FPGA-in-the-Loop, while this tutorial was designed for both Ethernet and JTAG connection. You just need to following the instructions specific to Xilinx JTAG.
To run this demo, you need Xilinx Vivado.
댓글 수: 4
Eduardo Flores
2020년 11월 29일
Hey @Irem, did you managed to solve the Device arm_dap_0 is not programmable error?
Antti Wredfors
2015년 9월 23일
I have some diffuculties with new 2015b release too. It's a litle bit same like previous post. The tcl file will not download bitstream correctly.
HDL Workflow advisor can sometimes program Zedboard, but usually it does not! If I use Vivado 2014.4 to download bitstream then it works. (Without tcl functions)
What I discovered was that "vivado_download.tcl"-file is not fully correct at this Vivado 2014.4 release. With Simulink 2015a and Vivado 2014.2 this works always correctly. But not anymore with new releases.
Original vivado_download.tcl file uses command "current_hw_target [get_hw_targets *]". If I remove this line from tcl file, then this works perfectly.
Is there any soutions for bitstream download issues?
BR Antti
댓글 수: 2
Ram Bhaskara
2020년 3월 28일
Hi! I did not understand how to get around this error. Can you please suggest the steps to get around it?
labtoolstcl 44-10 device arm_dap_0 is not programmable
Thanks!
- Ram
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!