Can antenna toolbox be used for Co-site interference analysis?

조회 수: 6 (최근 30일)
annie661
annie661 2015년 7월 16일
댓글: Jeffrey Johnson 2019년 5월 25일
For multiple antenna types (TX and RX), can interference analysis be performed with antenna toolbox?
  댓글 수: 2
Shashank Kulkarni
Shashank Kulkarni 2015년 7월 27일
No, Antenna Toolbox on its own currently cannot be used for interference analysis. However it would be nice to know more about your workflow. Maybe we can do something with Antenna Toolbox and RF Toolbox + SimRF.
Jeffrey Johnson
Jeffrey Johnson 2019년 5월 25일
To model the transmitter side of the radios: frame up some data packets with headers and CRC, encode at the desired baud rate, modulate these onto a carrier, and model the saturation and/or cross-over distortion of a power amp using an exponentiated raised cosine mapping. Feed this signal, one Fourier component at a time, into transmit antenna. Propagate from transmitter to receiver, through installed radiation patterns and S-parameters. Sum the responses from N-1 transmitters on each victim receiver.

댓글을 달려면 로그인하십시오.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Shashank Kulkarni
Shashank Kulkarni 2015년 10월 23일
No, Antenna Toolbox on its own currently cannot be used for interference analysis. However it would be nice to know more about your workflow. Maybe we can do something with Antenna Toolbox and RF Toolbox + SimRF.

카테고리

Help Center 및 File Exchange에서 Antennas and Electromagnetic Propagation에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by