Switches and if blocks wrong behavior?

I made a system with a switch but also a if action block. The behavior of both systems should be the same. The switch doesn't work and the if action block doesn't reset. I am expecting the same output as the input.

See the system here. And the output here.

[Titus Edelhofer]

Hi Lennart, I can see the system but the link to the output seems not to work ...?

[Lennart]

Thanks for your response, I fixed the link.

The switch block now seems to work. But I can't make the if action system reset. I should go to zero again but it doesn't..

Answer 1

[Titus Edelhofer]

Hi Lennart,

double click the output port in the if-action subsystem and do the following: (a) set the Initial Output to 0. (b) Set "Output when disabled" to "reset".

Titus

[Lennart]

Thanks! Would not have looked there!