Stop Windows MATLAB adjusting figure's position and size

I am writing some MATLAB code to export some graphics, which is "large". I tested my code on Windows system and I found that the position and size of the figure were adjusted.

I looked up the Help Center and saw the note (figure properties) as follows.

The Windows operating system enforces a minimum window width and a maximum window size. If you specify a figure size outside of those limits, the displayed figure will conform to the limits instead of the size you specified.

I wonder if there is some approah can stop Windows from changing the figure or adjust the minimum window width and maximum window size on Windows MATLAB?

I also tried to modify the position and size back. But I noticed that Windows MATLAB will change it back when I use `exportgraphics` to save the figure.

[SACHIN KHANDELWAL]

could you please share some code samples to reproduce the issue ?

[Cunxin]

@SACHIN KHANDELWAL

Sure. Try to run the following code in the directory where the attached 'fig.mat' stays.

load('fig.mat');
exportgraphics(fig, 'fig.pdf', 'ContentType', 'vector');

You will see the output pdf on Windows is different from that on Linux or MacOS.

The reason is what I mentioned above, but I don't know how to prevent it.

[Rik]

Since the issue is not actually related to Matlab, have you tried looking for general Windows fora for advice on how to change these settings?

Answer 1

[埃博拉酱]

你试过print吗？我一般用print出图，基本没有遇到过尺寸限制问题。

print(load('fig.mat').fig,'fig.pdf','-dpdf');