How to calculate only several frequency with FFT ?
조회 수: 4 (최근 30일)
이전 댓글 표시
Almost all cases, 1st, use FFT2 transfer to frequency field all , then to analysis like filter.
If I know only some frequecy are need,
Is it possible to calculate only several frequency not all frequencies with FFT ?
If OK, How to do?
for example, if ther are 512 data points, then will get 512 data points at frequency field, but I only need 0~50Hz,
How to tall FFT no need to calculated those data more than 50Hz ?
댓글 수: 0
채택된 답변
추가 답변 (1개)
Paul
2025년 1월 17일
If the desired frequenices are a subset of those that correspond to the DFT as computed by fft, I'd imagine in many cases there won't be a noticeable problem to call fft and then extract the desired subset of the results.
If the desired frequencies are not a subset of the DFT frequencies (or even if they are), then use freqz.
댓글 수: 2
Paul
2025년 1월 22일
편집: Paul
2025년 1월 22일
freqz can be used to compute arbitrary samples of the DTFT of any finite duration signal. The DFT samples are at specific frequencies of the DTFT.
To demonstrate, use freqz to compute the DTFT of x and show the DFT are samples of that.
rng(100);
x = randn(1,100);
Ts = 0.01;
xdft = fft(x);
wdft = (0:99)/100/Ts;
[h,w] = freqz(x,1,8192,'whole',1/Ts);
figure
plot(subplot(211),w,abs(h));
hold on
stem(wdft,abs(xdft))
plot(subplot(212),w,angle(h));
hold on
stem(wdft,angle(xdft))
The third argument to freqz can be used instead to specify specific frequencies of interest.
참고 항목
카테고리
Help Center 및 File Exchange에서 Transforms에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!