Unable to run PIL simulation using ESP-32

I am trying do PIL using ESP-32 Hardware and I am getting this error:

Error:Unable to run PIL simulation of "Subsystem".

Configuration parameters for the model do not support these connectivity configurations: STM32 Targets, Arduino Board, ARM Cortex-M3 (QEMU), STM32F4-Discovery (ST-LINK), STM32F4-Discovery (Serial), STM32 Ethernet, STM32 Microcontroller, Texas Instruments Code Composer Studio (IDE), Texas Instruments Code Composer Studio (TCP/IP), Texas Instruments Code Composer Studio (Serial), Teensy connectivity config using serial

Update configuration parameters or create a supported connectivity configuration. See Create PIL Target Connectivity Configuration.

Answer 1

[Abhinav Aravindan]

Hi Rakesh

It appears that you are facing issues with the “PIL” workflow on the ESP32 board. As per the documentation below, “Code Verification and Validation with PIL” is not supported with the ESP32 hardware.

Please find below the list of supported hardware for your reference:

https://www.mathworks.com/help/releases/R2024a/simulink/supportpkg/arduino_ref/code-verification-and-validation-with-pil.html#:~:text=validation%20using%20PIL.-,Supported%20Hardware%3A,-Arduino%20Mega%202560

For further information on the ESP32 set-up and configuration, you may refer to the documentation below:

https://www.mathworks.com/help/releases/R2024a/matlab/supportpkg/configure-setup-for-esp32-hardware.html

I hope this answers your question!