Pixhawk 6c : monitor and tune error when using telemtry

I'm currently using matalb2024a and using pixhak6c.

I want to control without using Radio Control, so I planned to use telemetry radio.

When monitor and tune simulation is started using USB (COM11), it works normally, but it does not connect when telemetry (/dev/ty/S5, COM3) is used.

Error: External Mode Open Protocol Connect command fails

Cause:

Could not connect to target application: XCP internal error: timeout expired, in response to XCP CONNECT command

In the Qgroundcontrol parameter setting, MAV_CONFIG_0 was set to disabled.

Is there a solution?

Answer 1

[Subhajyoti]

Hi,

This error has been extensively discussed in the community, and there have been numerous proposed workarounds. You may go through the following discussions where you can find valuable insights and potential solutions.

• https://www.mathworks.com/matlabcentral/answers/1988388-f28035-xcp-connection-error
• https://www.mathworks.com/matlabcentral/answers/2010587-xcp-on-serial-custom-board-c2000
• https://www.mathworks.com/matlabcentral/answers/1805400-why-am-i-getting-a-xcp-internal-error-timeout-expired-error-during-monitor-and-tune-for-ti-f280

I hope this helps.