How to simulate my custom drone in jMAVSim with Matlab PX4 simulink ?
조회 수: 9 (최근 30일)
이전 댓글 표시
I simulated a custom drone by replacing the STL files and Simulator.java file in the tools/simulation/jmavsim folder. And when i run the jMAV simulation from the PX4 make commands jMAVsim loads the custom model I given to it. But when I try to launch jMAVsim via simulink it loads the default 3dr_quadrotor. Kindly help me to load the simulator with my custom model when launching via simulink
댓글 수: 3
Mariam Amin
2024년 7월 9일
Hello, can you please tell me which stl files did you replace ? did you replace teh default aircraft files in the model folder?
채택된 답변
Arun Mathamkode
2024년 6월 11일
Based on my undertsanding the only difference is, from Simulink the SITL and jMAVSim are launched seperately. I am not sure how that is impacting the visualization. I assume you replaced the STL file and its name and locations are unchanged, so the jamvsim should fetch the new model by default. Simulink is not looking for any specific vehicle type and whatever jMAVSim fetches by default is displayed.
One workaround I can think is do monitor and tune from Simulink and then stop the simulation and manually launch the SITL and jMAVSim using make command. Then do connect from Simulink. Have alook at Disconnect and connect section of this documentation.
댓글 수: 0
추가 답변 (0개)
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!