Could not connect to Zynq hardware board using IP address 192.168.1.101.

조회 수: 12 (최근 30일)
koushik
koushik 2024년 4월 9일
댓글: Manikanta Aditya 2024년 4월 9일
Could not connect to Zynq hardware board using IP address 192.168.1.101.
Check that your device is connected to a LAN or direct network connection accessible from the MATLAB development computer
  댓글 수: 2
Manikanta Aditya
Manikanta Aditya 2024년 4월 9일
As mentioned, try checking your connection as well, and ensure that the USB cable is plugged into the ‘USB-to-UART’ port of the hardware and the power switch is turned on. If this error persists, switch off the hardware, wait for 10 seconds, switch on the hardware and then repeat this step.

댓글을 달려면 로그인하십시오.

이 질문에 답변하려면 로그인하십시오.

답변 (0개)

카테고리

Help Center 및 File Exchange에서 Targeting FPGA & SoC Hardware에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by