hi, i am using FEM based linear Actuator issue. I could not measure force and position at same time.

조회 수: 2 (최근 30일)
adhavan d
adhavan d 2024년 4월 8일
이동: Sabin 2024년 12월 12일
hi,
i am using FEM based linear Actuator issue. I could not measure force and position at same time.Please give Proper solution.

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Joel Van Sickel
Joel Van Sickel 2024년 4월 8일
이동: Sabin 2024년 12월 12일
Your force sensor is hooked up incorrectly. It is connected to two mechanical references. You need to connect it to the other side of the position sensor (the position sensor is an "open circuit" while a force sensor is a "closed circuit". I recommend searching for the free simscape onramp from mathworks to get the basics of using simscape.

커뮤니티

더 많은 답변 보기:  Power Electronics Community

카테고리

Help Center 및 File Exchange에서 Simscape Multibody에 대해 자세히 알아보기

태그

제품


릴리스

R2023b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by