필터 지우기
필터 지우기

Do OPC-UA blocks in simulink work with code generation?

조회 수: 2 (최근 30일)
Fredrik
Fredrik 2024년 3월 27일
댓글: Fredrik 2024년 3월 28일
If I set up my simulink controller to communicate through OPC-UA blocks can I then code-generate the controller and the opc-ua blocks into one deployable code package?
The goal is to deploy a controller that can run on its own in a container and also handle the OPC-UA communication.

채택된 답변

Andreas Goser
Andreas Goser 2024년 3월 28일
Not an expert here, but I found two new blocks as of R2024a here and here. Please confirm you a talking about those?
If yes, my viewpoint is they are not ready for code generation. My logic is that there is always a note about extended capabilities at the bottom of the page, see e.g. this Simulink block that says
Extended Capabilities
C/C++ Code Generation
Generate C and C++ code using Simulink® Coder™.
It is probably a good idea if you share your use case with MathWorks so an enhancement reqest can be created or you get linked to it. Technical Support is a good contact to submit enhancement ideas.
  댓글 수: 1
Fredrik
Fredrik 2024년 3월 28일
Thank you. Yes those look like the right type of block I would use.

댓글을 달려면 로그인하십시오.

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Communications Toolbox에 대해 자세히 알아보기

제품


릴리스

R2024a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by