필터 지우기
필터 지우기

Cell balancing of Li-on battery

조회 수: 1 (최근 30일)
Nalla Muthu
Nalla Muthu 2023년 7월 27일
댓글: Nalla Muthu 2023년 8월 2일
Hi,
I am trying simulation of battery behaviour of lithuim ion battery. In simulation total 6 batteries are connected in series and parallel. once cell balancing are used, i can't get output of aging and temperature. I have used battery block from simscape. Let know problem or example of battery aging with cell balancing.
  댓글 수: 2
Joel Van Sickel
Joel Van Sickel 2023년 7월 28일
can you share your model? This is not enough information to help you.
Nalla Muthu
Nalla Muthu 2023년 7월 31일
Hi,
Please find the model I have used for aging.

댓글을 달려면 로그인하십시오.

답변 (1개)

Javier Gazzarri
Javier Gazzarri 2023년 8월 1일
Hello Nalla,
When I run your model I can see the temperature output (please make sure you enable temperature effects) and the cycle count equal zero means that the simulation time is far too short to show significant aging. Please keep in mind that the cycle count is equal to one once the integral of the current in absolute value is equal to twice the capacity. In your case, C = 2.6 Ah, which means that one cycle will be counted once 5.2A have passed through the battery for one hour, which is much longer than what you have set.
Please let me know if this clarifies the issue.
Best regards,
Javier
  댓글 수: 1
Nalla Muthu
Nalla Muthu 2023년 8월 2일
Hello Javier Gazzarri,
Previously I have tried with enabling temperature and aging but I can't get number of cycle. In simulation
battery starts discharge before battery reaches 100% SOC.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Sources에 대해 자세히 알아보기

제품


릴리스

R2022b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by