필터 지우기
필터 지우기

What solver need to be used to run the simscape model?

조회 수: 2 (최근 30일)
Noor Amira Ilyanie
Noor Amira Ilyanie 2023년 6월 6일
답변: Nathan Hardenberg 2023년 6월 6일

채택된 답변

Nathan Hardenberg
Nathan Hardenberg 2023년 6월 6일
You always need a "Solver Configuration"-Block connected to your circuit/physical diagram (see below). In there you can make a few settings, but in most cases just using default values is sufficient. You can also make changes to the Solver in the Model Settings. But leaving the solver on "auto (Automatic solver selection)" works great in most cases. Hope this helps
Small tip: Please write a few sentences on your problem next time and provide error messages. Otherwise it is very hard to know what your actual problem is

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Troubleshooting에 대해 자세히 알아보기

태그

제품


릴리스

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by