Why Execution Order of Sum block is not shown in the Simulink model?
조회 수: 10 (최근 30일)
이전 댓글 표시
Following is a snapshot of my simulink model.
The Information Overlays in the Simulink provides the Execution Order of the blocks.
In my model for some blocks the execution order is shown but for others it is not. I am curious why it is so? (why execution order of Sum and Relational Operators are not visible below?)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/1400849/image.png)
댓글 수: 0
답변 (1개)
Paul
2023년 6월 1일
It's possible that Simulink has determined that those blocks don't need to be executed (I think there is a Block Reduction optimization option). What happens if a Scope is attached to the output of a Sum block so that the Sum block must execute? Does that make that Sum block show up in the execution order?
댓글 수: 5
Paul
2023년 6월 4일
Don't know when "Reduced Blocks" was added to Information Overlays. I'm using 2022a.
Again, adding the Scope is only intended as test to see if the block in quesition is being reduced out of model, in order to answer your question of why a block is not shown in the execution order. At this point, I'm only guessing that the blocks in question are being reduced out of the model.
Another option to determine if block reduction is causing the blocks in question to not be shown in the exeuction order is to turn off block reduction. In R2022a, block reduction can be turned off by going to
Model Settings -> Simulation Target -> Advanced Parameters
and uncheck Block Reduction. I assume it would be the same in 2020a
참고 항목
카테고리
Help Center 및 File Exchange에서 Schedule Model Components에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!