- The 3-phase output from the block Permanent Magnet Synchronous Machine can be connected to a 3-phase uncontrolled diode rectifier. The rectifier can be implemented using six Diode blocks (available at Simscape/Electrical/Specialized Power Systems/Power Electronics). To reduce harmonics, the output of the rectifier can be filtered using a capacitive filter to feed the DC load.
- The 3-phase output from the block Permanent Magnet Synchronous Machine can be connected to a 3-phase controlled rectifier. The difference from the previous technique is six controlled switch blocks like Mosfet (available at Simscape/Electrical/Specialized Power Systems/Power Electronics) have to be used here. An appropriate control algorithm can be developed to provide PWM pulses to the gate of the Mosfet. In this case too, a capacitive filter can be added in cascade to feed the load.
Solar and wind hybrid energy system using P&O MPPT algorithm
조회 수: 16 (최근 30일)
이전 댓글 표시
This is how far i could manage to reach. I cant integrate both the wind and solar energy system to connect them to a load and check the output waveform.
Any help in how to do this is greatly appreciated.
Thank You.
댓글 수: 0
답변 (1개)
Sayan
2023년 9월 1일
I understand from your query that the solar and wind energy systems need to be connected to the common DC bus or the load (the output resistor in this case). The different ways this can be done are as follows:
Hope this helps resolve the query.
댓글 수: 1
wardah Afzal
2023년 12월 28일
Hello
Sir can you provide any charging controller simulation for hybrid of wind solar with battery stoarge?
참고 항목
카테고리
Help Center 및 File Exchange에서 Electromechanical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!