I am getting an error 'Output Port 1' of 'Wind_Turb​ine/Scopes​/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output

조회 수: 2 (최근 30일)
Karam Karas
Karam Karas 2023년 4월 7일
답변: Dimitri MANKOV 2023년 4월 11일
I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output ?

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Dimitri MANKOV
Dimitri MANKOV 2023년 4월 11일
Hi Karam,
It looks like these output ports are not used anywhere in your model, so you can simply delete them to get rid of the warning message.
I hope this is helpful!
Dimitri

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Model, Block, and Port Callbacks에 대해 자세히 알아보기

태그

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by