Parallel Computing Toolbox and parsim: two different versions of Matlab?

조회 수: 6 (최근 30일)
Alessandro Longo
Alessandro Longo 2023년 3월 24일
답변: Raymond Norris 2023년 3월 24일
Hello everyone,
I installed Parallel Computing Toolbox on my Matlab 2014a in order to run multiple Simulink runs but discovered that probably parsim command is not identified on my release.
According to system requirements, Parallel Computing Toolbox has been introduced on Matlab 2008 but parsim is identified from Matlab 2017 version.
Is this possible? Is there a workaround to run multiple simulation on Matlab 2014 without using parsim?

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Raymond Norris
Raymond Norris 2023년 3월 24일
Consider using parfor and sim, but read this first
Using sim Function Within parfor - MATLAB & Simulink (mathworks.com)

카테고리

Help Center 및 File Exchange에서 Programmatic Model Editing에 대해 자세히 알아보기

태그

제품


릴리스

R2014a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by