Why is MATLAB not making multiple plots when I specify separate figures?
조회 수: 122 (최근 30일)
이전 댓글 표시
Hello, I am attemping to plot two separate sets of data on two different figure windows. I used the following code:
figure(1);
plot(theta, p);
figure(2);
plot(theta, T);
But only figure 1 is showing up. I have looked through this forum and I haven't seen any solutions, so some help would be greatly appreciated.
댓글 수: 0
답변 (2개)
Voss
2023년 3월 10일
편집: Voss
2023년 3월 10일
figure(2)
makes Figure 2 the current figure, if it exists, or creates a new figure called Figure 2 if it does not already exist and makes it the current figure.
It may be that Figure 2 already exists and its Position is outside the range of your monitor(s) or it's very small and you don't notice it.
Regardless, if you want to create a new figure, use
figure()
So this
figure();
plot(theta, p);
figure();
plot(theta, T);
would create two new figures, each with the their own plot(s).
Image Analyst
2023년 3월 10일
You could put
close all
at the beginning of your script to close all windows. It should work then, though I'm not sure why it didn't work in the first place.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Annotations에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!