- The start of the motion is extremely abrupt, jerking the mass forward with a high acceleration and then slowing down to steady state speed. The crane is then actually slowing the mass down, causing it to swing forward.
- The CG of the block is above the point where it is attached to the rod AND a rotational spring is holding it in it its current position.
Simscape end mass swings in the opposite direction
조회 수: 3 (최근 30일)
이전 댓글 표시
I have a crane model. In this model, when the crane starts compressing, the free mass at the end connected with a revolute joint is supposed to swing backwards, instead it swings in the forward direction. Can someone tell why this is happening?
댓글 수: 0
채택된 답변
Steve Miller
2023년 3월 12일
Without looking at the model directly, it is hard to say for sure.
Some possibilities:
--Steve
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Assembly에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!