How to plot graphs successively using loop

Hi, I would want to plot data successively using for loop. I tried the code below, but the code only plots the first graph and stops. How can I plot the graph successsilvely. You can use any data for illustration. The code should selcet montlhy data from a data set, find the parameters and then use the results to generate 12 graphs. The code does all these successfully except darwing the graphs, it draws only the first one. How can I modify my code to be able to darw the graphs?

A=input('Enter wind speed\n')

B=input('Ener matrix of month\n')

% monthly Weibull parameters

c=12;

a1=400;

C1=[A B];

for k=1:1:c

selectedRowsLogicalIndices = B == k;

if numel(B(B==k))>a1;

subsetAdata = A(selectedRowsLogicalIndices);

Monthly_parameters(:,k)= wblfit(subsetAdata);

[Overal_parameters]= wblfit(A);

if k==c

display(Monthly_parameters)

display(Overal_parameters)

figure()

histogram(A,50,'Normalization','probability')

hold on

plot(A,wblpdf(A,Overal_parameters(1),Overal_parameters(2)))

legend('Observed Samples','Estimated Distribution')

xlabel('Annual probabilty density')

ylabel('wind speed m/s')

hold off

%mothly plots

%january

figure()

histogram(subsetAdata,50,'Normalization','probability')

hold on

plot(subsetAdata,wblpdf(subsetAdata,Monthly_parameters(1,k),Monthly_parameters(2,k)))

legend('Observed Samples','Estimated Distribution')

xlabel('monthly probabilty density')

ylabel('wind speed m/s')

hold off

end

else

F(k,:)=find(C1(:,2) ==k);

if k==c

display(F)

end

end

end

Answer 1

[Luca Ferro]

I think the issue is with the if statement:

if k==c

since the plotting happens inside of the if statement it will only happen when the condition is true, in this case only on the 12th run. So what you get is only 1 graph, of the 12th run in the loop (when c==k==12)

[Luca Ferro]

did this solve your issue?