Parameter estimation in steady state to match measurement data ( for a particular range)
조회 수: 3 (최근 30일)
이전 댓글 표시
I am trying to implement parameter estimation for full switching model of EV battery charger and fine tune values of L, C components as well as control loop parameters Kp, Ki. I have 10 cycle steady state measurement data @ 50Hz for input current of actual charger (signal length 0.2 sec)
.
However, my model simulation has to be done for total of 0.26 sec (13 cycles) to get 10 cycle steady state data, where first 3 cycles are required for the model to stabilize
My question is how I can set the parameter estimation to start at 0.06 sec, i.e after first 3 cycles have passed and do the parameter estimation for next 3-4 cycles. In other words, do the parameter estimation from 0.06 sec to 0.12 sec instead of doing for the whole 10 cycle data.
댓글 수: 2
Sai
2022년 11월 23일
Hi Haroon,
Can you please share the Simulink model or MATLAB code so that I could reproduce the graph and work on it?
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Verification, Validation, and Test에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!