Memory not Initialized in Simulink HDL causing problems in FPGA simulation.
조회 수: 2 (최근 30일)
이전 댓글 표시
The FPGA simulation, like modelsim, does not like reading from not initialized memory, it creates undefined signals. But I cannot reproduce this problem in Simulink HDL since all memory are initialized to zero at startup by default.
Is there a way for Simulink to assume that memory at startup is undefined and at least give a warning if it reads from undefined memory?
댓글 수: 0
답변 (1개)
Kiran Kintali
2022년 11월 10일
RTL Customization Parameters for RAMs
This page describes parameters that reside in the HDL Code Generation > Global Settings > Coding Style tab of the Configuration Parameters dialog box.Initialize all RAM blocks
Enable or suppress generation of initial signal value for RAM blocks. If you specify a nonzero initial value for the RAM, this setting is ignored.
Default: On For RAM blocks, generate initial values of '0' for both the RAM signal and the output temporary signal.
Off: For RAM blocks, do not generate initial values for either the RAM signal or the output temporary signal.
댓글 수: 2
Kiran Kintali
2022년 11월 10일
I think you are asking for a Simulation behavior change on the RAM blocks. Please reach out to tech support with your request. Thanks
참고 항목
카테고리
Help Center 및 File Exchange에서 Model Verification에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!