How to create meshgrid for unequal metrix.
조회 수: 45 (최근 30일)
이전 댓글 표시
I am trying to plot pressure contour for roof (40'X125') where 8 main tap lines are given and another 7 sub tap lines starts after 99'; hence, tributary dimensions in 1 direction is reduced after 99'. Therefore, how to create meshgrid in this case. Image is given here for the reference.
댓글 수: 0
채택된 답변
William Rose
2022년 11월 3일
The answer below shows how to create a grid that is non-uniform. The figures in the answer show how it worked.
However, the answer above does not reproduce a pattern like the one in your figure. meshgrid() cannot make a mesh like the one in your figure, because your figure has different numbers of rows for different columns.
I do not understand exactly what you are trying to do with the diagram shown. Do you have measurements at the dots shown on the diagram, and you want to make a contour plot using the measured values?
.
댓글 수: 5
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Contour Plots에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!