UAV Toolbox Support Package for PX4 Autopilots-finish upload firmware

조회 수: 11 (최근 30일)
一 悟空
一 悟空 2022년 10월 27일
답변: Arun Mathamkode 2022년 11월 4일
When I followed the normal steps to burn the flight controller firmware of v1.10.2 to pixhawk 2.4.8 (2mb flash memory), I was able to get the acceleration correctly, but when the burned PX4 connected to QGC, the firmware version was not recognized, and the led light on the PIXHAWK was abnormal (the BE light at IO was always on), I wanted to know if this is normal

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Arun Mathamkode
Arun Mathamkode 2022년 11월 4일
You can refer to the PX4 documentation to understand these status LED's and their meaning.

카테고리

Help Center 및 File Exchange에서 PX4 Autopilots에 대해 자세히 알아보기

태그

제품


릴리스

R2021b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by