I have to run a controller through arduino that controls a motor for a specifc purpose. I have designed the Model predictive controller in Simulink with my model, and everything works as intended. Is it possible, instead od reading values from the simulated model, to receive real values from an arduino board into matlab and use those in the control implementation on simulink, then send the control signal back? Say for example in my simulated model, I measure some variable, x. I measure this x in the simulation, feed it back to the MPC, compute a control signal, then send that to the simulated plant. Is it possible to instead, receive x into my simulink model from my arduino board (would be measured from the physical model), use this x in my MPC controller, and send the computed control signal back to my arduino where further processing and actuating of the various physical systems can be done?
