How do I translate a variable into HSV color values?
조회 수: 1 (최근 30일)
이전 댓글 표시
I have this project where I am interfacing MATLAB with an Arduino board and reading input from an analog pin connected to a potentiometer. I want to use the voltage values read from the potentiometer to control the color of a rectangle. The voltage read is stored in the variable voltage
I have the following code:
while true
voltage = a.readVoltage('A0');
color = ??voltage??
fill([0 1 1 0], [0 0 1 1], color)
pause(0.1)
end
I would like to map the variable voltage to an HSV color value, specifically controlling the H(hue) parameter - so than when I turn my potentiometer wheel, I basically cycle through the different colors of the color wheel (ie change the hue). Is this possible? Any help is appreciated. Thanks.
Edit: the value of the voltage variable is in the range 0 - 5.
댓글 수: 0
채택된 답변
William Rose
2022년 7월 15일
Vmax=5;
while true
voltage = a.readVoltage('A0');
color = hsv2rgb(voltage/Vmax,1,1);
fill([0 1 1 0], [0 0 1 1], color);
pause(0.1)
end
Try the above. I tested it with the following modified code, which does not require an external input. It worked as expected, generating a whole range of colors from R to Y to G to C to B to M to R.
Vmax=5;
for i=0:24
voltage = i*Vmax/24;
color = hsv2rgb(voltage/Vmax,1,1);
fill([0 1 1 0], [0 0 1 1], color);
pause(0.5)
end
Good luck.
댓글 수: 2
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Arduino Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!