I want to continue sending data to Thing Speak using the Arduino MKR WiFi 1010

Currently, I am trying to send GPS sensor data to ThingSpeak in real time.

I made the Arduino MKR WiFi 1010 build, distribute and start the program. Then, the data is sent to ThingSpeak only once at the moment when the plug ram is inserted, but the data is not sent after that.

Is there a solution?

Thank you very much!

[Christopher Stapels]

Nice model! Its nice to see use of Simulink for seployment of ThingSpeak projects.

What do you have the update interval set to?

Can you confim hat the model is working otherwise? For example, you could flip a bit at the output of the GPS data block that you could sample with a DMM or scope probe to be sure the model is stuill running.

The ThingSpeak blocks will also work in simulation mode, do the updates to ThingSpeak work in simulaiton before you deploy?

[seiya moro]

Mr. Christopher,

Thank you for your response.

The update interval is set to 1 second.

The sampling time of the GPS sensor is set to 0.03 seconds for the sake of data acquisition.

In the simulation mode, we have not checked yet.

In addition, the following error message appears when the monitoring and adjustment is performed.

External Mode Open Protocol Connect command failed.
Cause
DWARF Parser internal error: Parser::initialize failed to create object file

Unable to connect to 'Arduino MKR WIFi 1010' target in 'untitled'.

Thank you very much.

[Christopher Stapels]

Do you have a paid ThingSpeak license? A paid license is required for updates at 1 second.

I would set the update time slower (20 seconds perhaps) at the start just to be cautious, and increase it later.

What do you mean by "when the monitoring and adjustment is performed." Have you been able to successfully delpoy previously?

I would focus on the simulation more (hardware in the loop) and make sure you can get the ThingSpeak part working there first. You might even try another model with just the ThingSpeak block hoocked up to a constant to help you troubleshoot.

[seiya moro]

I have a license.

I would like to try it once, in 20 seconds.

'when the monitoring and adjustment is performed' is the button circled in red.

I would like to check this with other, constant values.

Thank you very much!