I want to run a loop until a value is reached and, then, I want to use that reached value to continue the loop

조회 수: 11 (최근 30일)
Hi everyone! Thanks for helping.
I'm running a code about hydrogeology. I'm calculating tha saturated portion of a soil depending on rainfall amount.
I need Matlab to calculate this saturated thickness until a certain value H is reached. This value is the maximum depth of the soil of course.
When the loop reaches H, I want Matlab to keep on doing the calculations assuming H as the new starting point, instead of the value > H that it has been encountered.
How can I do this? Thanks for helping!

채택된 답변

Voss
Voss 2022년 4월 13일
Hard to say for sure, but maybe some structure like this (but with a break condition - which was unspecified in the question):
H = 100;
thickness = 0;
while true
thickness = thickness+1;
if thickness >= H
thickness = thickness-H;
end
end

추가 답변 (1개)

jjjSAN
jjjSAN 2022년 4월 14일
Many many thanks!! Finally I managed by doing this:
ii = 1;
m(1) = m0;
deltam(1) = 0;
output(1) = 0;
while true
ii = ii + 1
output(ii) = prod*m(ii-1);
deltam(ii) = ((input(ii)-output(ii))./den2(ii));
m(ii) = (m(ii-1) + deltam(ii));
if m(ii) >= H;
m(ii) = H;
end
end
  댓글 수: 4
jjjSAN
jjjSAN 2022년 4월 14일
Finally I just added an if loop inside the code I posted earlier:
if ii > a (a was the length of my dataset)
break
end
And so it runs normally now :D

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 MATLAB Coder에 대해 자세히 알아보기

제품


릴리스

R2022a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by