Using shared configurations with configured hardware board

Hi,

I'm using a shared configuration as described here: https://www.mathworks.com/help/simulink/ug/referencing-configuration-sets.html

This seems to work fine until I set Hardware Implementation > Hardware board to "Raspberry PI". When I do this I get the following error when opening a model using the shared configuration :

------------

Parameter update is not supported for a configuration reference. Update parameter in the configuration set that it references.

Component:Simulink | Category:Model error

-----------------

And then I do not get hte Hardware tab I usually get when not using shared configurations.

Does anyone know why this isn't working?

Thanks in advance!

[Hangxu Li]

I also have the same problem when using 21a. But it works for 23a now. Did you find any solution to this problem?

Answer 1

[Nakul Khadilkar]

Hi Kristian,

Try setting the configuration parameter as below:

configurationSettings.set_param('Name', 'value');

‘configurationSettings’ should be a variable in your workspace and the variable’s name should match Referenced configuration set name in the Model Explorer.

-Nakul

Answer 2

[Divya]

Hi,

need to take referenced Configuration object that model config references,and then set required parameter.

configSet = getActiveConfigSet(modelName);

referencedConfigObj = getRefConfigSet(configSet); % taking referenced Configuration object

set_param(referencedConfigObj, 'parameter_name', 'value');