Running parfor loop in R2013a
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi, all,
I have delopved a tool based on R2020b with a few parfor loops in it. This tool has been compiled and ran in a server based on R2013a and parfor loop isn't running.
- My question is does parallel computing toolbox comes with R2013a?
- In 2020B, I run my parfor loop without specifying the number of cores or wokers. Do I need to do that in 2013a (e.g. matlabpool (4))?
Best,
Steve
댓글 수: 0
채택된 답변
Edric Ellis
2022년 2월 25일
Yes, Parallel Computing Toolbox was available for R2013a. Yes, in R2013a, you need to explicitly create the parallel pool using the old (now obsolete) syntax matlabpool(4) or similar.
댓글 수: 2
Walter Roberson
2022년 2월 25일
It is not possible to purchase a license for r2013a toolboxes anymore.
What is possible at this point is to purchase a license for the current version of MATLAB and the Parallel Computing Toolbox. Then if you had particular reason to use R2013a (compatability mostly) then your new license key would also be valid for any previous version including R2013a.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Startup and Shutdown에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!