to form a helix spiral
조회 수: 3 (최근 30일)
이전 댓글 표시
Dear all
I am unable to for a helix spiral using attached code.
First i want to mirror the generated curve in opposite direction and then i want a helix spiral to be formed with certain height and with certain gap. The gap can be taken as 0.5 and height as 60 mm.
The code is attached below.
Thank you
clc
R=30; %% radius of curvature
W=0.0125; %% width of grating
r=10; %% radius of workpiece
th_1=(asin(W/R)); %% angle at which blazed grating existd
th_2=2*(asin(r/R)); %% angle at which primary profile exists
n=round(degr_2/degr); %% number of grating
for i=1:n
th (i)= (((i*th_1)-((th_2)/2)));
x(i)= -(R*cos(th (i)));
z(i)= (R*sin(th (i)));
end
X1=x;
Z1=z;
figure (1)
plot(X1,Z1); hold on
댓글 수: 0
채택된 답변
Voss
2022년 1월 13일
편집: Voss
2022년 1월 13일
clc
R=30; %% radius of curvature
W=0.0125; %% width of grating
r=10; %% radius of workpiece
th_1=(asin(W/R)); %% angle at which blazed grating existd
th_2=2*(asin(r/R)); %% angle at which primary profile exists
% n=round(degr_2/degr); %% number of grating
n = 1e5;
for i=1:n
th (i)= (((i*th_1)-((th_2)/2)));
x(i)= -(R*cos(th (i)));
z(i)= (R*sin(th (i)));
end
X1=x;
Z1=z;
Y1=th;
figure (1)
% plot(X1,Z1); hold on
plot3(X1,Y1,Z1);
xlabel('x');
ylabel('th');
zlabel('z');
view([30 60])
댓글 수: 2
Voss
2022년 1월 13일
clc
R=30; %% radius of curvature
W=0.0125; %% width of grating
r=10; %% radius of workpiece
th_1=(asin(W/R)); %% angle at which blazed grating existd
th_2=2*(asin(r/R)); %% angle at which primary profile exists
% n=round(degr_2/degr); %% number of grating
n = (2*pi/th_1)*120;
for i=1:n
th(i) = i*th_1 - th_2/2;
x(i)= -R*cos(th(i));
z(i)= R*sin(th(i));
end
X1=x;
Z1=z;
Y1=th./(240*pi-th_2/2)*60;
figure (1)
% plot(X1,Z1); hold on
plot3(X1,Y1,Z1);
xlabel('x');
ylabel('th');
zlabel('z');
view([30 60])
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Graphics Object Programming에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!