Simscape is aligning tyre wrong.
조회 수: 1 (최근 30일)
이전 댓글 표시
I am designing a suspension system. However, when ı want to connect tie rod to the upright, it is connecting it from the other side by rotating the tyre 180 degree such that inside of the tyre is facing out. What can I do to make the program that it connecting tie rod to the upright in a correct tyre orientation.
댓글 수: 0
채택된 답변
Steve Miller
2021년 11월 25일
The initial position of the joints can be influenced using joint targets.
Those are set within the joint. Here is a screenshot of the Revolute Joint with the desired angle set to 180 deg.
You can check your assembly by opening the Simscape Variable Viewer.
Here is a screenshot showing that not all joints achieved their desired initial positions from model sm_double_wishbone_suspension
If you are modeling suspensions, you also should take a look at the Simscape Vehicle Templates. This is a free set of templates for modeling vehicle dynamics and vehicle powertrains in Simscape. You can see many animations on this page:
--Steve
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Simulation and Analysis에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!