how to change the parameter in simulation while the simulation is run
조회 수: 1 (최근 30일)
이전 댓글 표시
i want to change the parmeter using kanob to run the simulation continousely
댓글 수: 0
채택된 답변
Pavan Guntha
2021년 11월 18일
Hello Shehab,
You could vary a parameter value using the knob while the simulation is in progress by slowing the simulation pace as shown below:
You could also look at the following example which illustrates the intended behaviour:
Hope this helps!
댓글 수: 0
추가 답변 (0개)
참고 항목
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!