can i run and directly modify a simulink model on a beaglebone black that is connected via wifi?

조회 수: 1 (최근 30일)
I have the model in simulink and also I have configured the wifi adapter (in this case I use the interface that has the BEAGLEBONE board for setup ip fo the communication). It is possible that I can run the model simulik directly from matlab without having to intervene in linux interface, ie, if I change a value to model simulink real time, BEAGLEBONE board recive the data and runs it, for example, ordered to move an actuator?

답변 (2개)

Hong Ye
Hong Ye 2014년 10월 29일
it is possible to run the model in external mode and tune the parameter (assume it is tunable in your Simulink model) at run-time.

Murat Belge
Murat Belge 2014년 11월 19일
Assuming you have installed the Embedded Coder Support Package for BeagleBone Black hardware, yes. Simulink requires a TCP/IP connection to run a model on BeagleBone Black hardware. Wired or wireless does not make a difference.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by