MATLAB Answers

0

See Generated code from Realtime workshop for Arduino

phil 님이 질문을 제출함. 26 Aug 2014
최근 활동 phil 님이 답변함. 5 Sep 2014
Rather simple question:
How can i see the generated code when i use the realtimeworkshop with the Arduino Target?
deployment works fine and code works like a charme. I would just like to see what matlab is actually sending to the Arduino (generated c code...)

  댓글 수: 0

로그인 to comment.

답변 수: 2

Answer by AJ von Alt
on 26 Aug 2014

Generated C code can be reviewed by enabling the Code Generation report.
In the Configuration Parameters dialog box select Real-Time Workshop( Code Generation in newer versions) > Report and check "Create code generation report" and "Open report automatically".
The generated code can also be found in the code generation folder. This folder is typically located in the working directory and has the same name as the model.

  댓글 수: 0

로그인 to comment.


Answer by phil
on 5 Sep 2014

Hi Aj,
thanks for your reply.
That is exactly what i tried but then when i try to run the model on the hardware the following messages shows up:
_"The model parameters are not configured for the target hardware. You must configure the model parameters before you can generate an application that can run on the target hardware.
To configure the model parameters, click 'Yes'.
To leave the model parameters unchanged, click 'No'."_
when i click yes it reverts the changes i just made and runs fine. when i click no it does not run :/

  댓글 수: 0

로그인 to comment.



Translated by