MATLAB Answers

Visualizing a wav file

조회 수: 5(최근 30일)
Olalekan Adesina
Olalekan Adesina 2021년 10월 9일
댓글: Walter Roberson 2021년 10월 14일
Hi everyone. I have a .rec file that contains 14 different signals. When i open the .rec file in R Studio, my target signal was at Number 8. Then, i converted the file from .rec to .wav file. Please,can someone help with how i can visualize the .wav file to see the list of the signals?
  댓글 수: 9
Olalekan Adesina
Olalekan Adesina 2021년 10월 10일
The file size is above 5MB

댓글을 달려면 로그인하십시오.

답변(1개)

Tanmay Das
Tanmay Das 2021년 10월 12일
Hi,
To my understanding, you are facing issues in reading .wav file in MATLAB. You can use audioread function to read data from the file, and receive sampled data and a sample rate for that data. For visualization, the following code snippet can be referred:
[y,fs] = audioread(filename);
dt = 1/fs;
t = 0:dt:(length(y)*dt)-dt;
plot(t,y); xlabel('Seconds'); ylabel('Amplitude');
figure
plot(psd(spectrum.periodogram,y,'Fs',fs,'NFFT',length(y)));
You can refer to audioread and periodogram documentations for further information.
  댓글 수: 2
Walter Roberson
Walter Roberson 2021년 10월 14일
You should open a new Question for that, as it is not related to this one.
When you open the new question, you should indicate there how you can tell where the boundaries are between the categories for each participant. Also, since you are talking about "seconds", whoever responds to your new Question is going to need information about the recording frequency.

댓글을 달려면 로그인하십시오.

태그

제품


릴리스

R2020a

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by