필터 지우기
필터 지우기

How to add the wiring of two resistors in SIMULINK through the MATLAB code

조회 수: 10 (최근 30일)
I want to add the wiring of two resistors through the code. As shown in the figure, I first added the Resistor999 module using the code, and then added two resistors, Resistor and Resistor1, and made the connection as shown in the figure in Simulink. I want to add the connection on the right side of Resistor999 and the left side of Resistor1 through the Matlab code.
First use get_param to find out that LConn and RConn in LineHandles should be related to the resistance interface, try to use add_line to add a connection line, but no matter how you try, Invalid Simulink object name is displayed. How to use code for help, thank you!
I would also like to ask how to add the resistor to the specified position through the code, and how to delete the specific connection through the code, thank you!

채택된 답변

Kumar Pallav
Kumar Pallav 2021년 9월 29일
Hi,
You can perform simulink basics modelling from matlab command window. Refer this for more on Programmatic Modeling Basics.
You can use routed lines, port handles, or port IDs to add a line to connect blocks. Refer examples mentioned here to acheive the same.
Hope this helps!

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Programmatic Model Editing에 대해 자세히 알아보기

태그

제품


릴리스

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by