Can I adjust the matrix of state-space model during simulation in Simulink?
조회 수: 8 (최근 30일)
이전 댓글 표시
I want to change the system matrix during the dynamic simulation within the Simulink. I can do that with following codes using the command "lsim": ..... %%Stage I X1 = lsim(sys_1,u(1:100),t(1:100)); %%Stage II X2 = lsim(sys_2,u(101:end),t(101:end),X1(end,:)); %%X1(end,:) is the last state of Stage I and to be the initial state of Stage II .....
But for convenient, I prefer the simulation to be performed in the Simulink with the block "State-space". How could I to integrate the above two lsims into one Simulink model with some special design and blocks?
Thank you!
댓글 수: 0
채택된 답변
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Assembly에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!